CID 2483 CAT Fault Code

Steering Hydraulic Metering Unit Pressure Switch

Cause :

This sub type is used for control module Internal Failures that cannot be assigned to a specific sub type.Engine started, engine running, and the PCM detected a high voltage present at the PCM for 3 minutes after the engine started. The Starter Relay Control Circuit High Voltage test monitors the voltage signal that is sent from the ignition switch.

CID-683
CID-1518
CID-1216
CID-1166
CID-2337
CID-2467
CID-3575
CID-140
CID-2701
CID-935

Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Catfaultcode.com is not a part of Cat brand. CAT is a trademark that we trust.