CID 345 CAT Fault Code

DeNOx Hydrocarbon System Pressure Sensor

Cause :

The control unit indicates problems in the operation of the throttle. For an unknown reason, the control module was not able to provide training in the limit position of the node.Engine started, engine running, and the PCM detected a high voltage present at the PCM for 3 minutes after the engine started. The Starter Relay Control Circuit High Voltage test monitors the voltage signal that is sent from the ignition switch.

CID-464
CID-1237
CID-1568
CID-952
CID-796
CID-1076
CID-3301
CID-2750
CID-2805
CID-1552

Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Catfaultcode.com is not a part of Cat brand. CAT is a trademark that we trust.