CID 748 CAT Fault Code

Rotor Door Switch

Cause :

The control unit indicates problems in the operation of the throttle. For an unknown reason, the control module was not able to provide training in the limit position of the node.Engine started, engine running, and the PCM detected a high voltage present at the PCM for 3 minutes after the engine started. The Starter Relay Control Circuit High Voltage test monitors the voltage signal that is sent from the ignition switch.

CID-3395
CID-962
CID-3333
CID-3586
CID-809
CID-1002
CID-418
CID-3337
CID-3639
CID-2709

Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Catfaultcode.com is not a part of Cat brand. CAT is a trademark that we trust.