FMI 449 CAT Fault Code

Implement Not in Hold State With No Operator In Seat

Cause :

The cause of the problem may lie in the knock sensor, as well as in the use of low-quality oil or in the breakdown of one of the components of the ignition system.Engine started, engine running, and the PCM detected a high voltage present at the PCM for 3 minutes after the engine started. The Starter Relay Control Circuit High Voltage test monitors the voltage signal that is sent from the ignition switch.

FMI-2014
FMI-407
FMI-384
FMI-240
FMI-661
FMI-2139
FMI-1050
FMI-1069
FMI-1110
FMI-253

Don't forget ! When a fault code pops up, CAT's Uptime Center is automatically notified via an cellular link, and it alerts the truck's owner by prearranged methods, usually email or phone calls.

About | Contact | Privacy

Catfaultcode.com is not a part of Cat brand. CAT is a trademark that we trust.